DK Digital CDB-600 Specifikace stáhnout pdf (Strana 52)

Appendix A Hardware Specifications. PRELIMINARY Release MSD Software Manual.

A.1.3 2 Channel Digital Input Module.

Type Number: MSD600M-Input-2D/O

Description: Input module with 2 digital inputs.

Supported by: MSD600M, MSD600M++, PT0600M, PT0660M, PT0660M-LS

Digital Inputs:

Dual AES-3 Input Module. The inputs are equipped with sample rate converters

to synchronize the inputs to the internal clock. The sample rate converters may

be by-passed. In this case the base unit should be synchronized externally by

an AES-3 signal applied to the sync input on the utility connector.

Sample rate range: 30 Hz to 100 kHz

Internal sample rate: 48 kHz

Bit resolution: 24 bits

Group delay: maximum 1.75 msec

Passband ripple: ±0.008 dB

Total harmonic distortion and noise: typical –103 dB at 1 kHz

Dynamic range: larger than 120 dB

Nominal input impedance: 110 ohm

Possible placement: Priority B

, Input slot #1, #2, #3 and #4.

Modules with higher priority must be placed in input slots with a lower number, starting with input slot #1.

Modules with the same priority can be interchanged.

Connector type: 25 pin Female D-Sub

Pin Configuration:

Page 48 of 64 PRELIMINARY Release

Signal Name. Pin number.

AES-3 Channel 1 Hot 2

Cold 9

Ground 1

AES-3 Channel 2 Hot 11

Cold 3

Ground 10

Ground 4

Ground 12

View from solder side of the 15 pin

MALE D-Sub connector.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 67 68

Žádné komentáře

DK Digital CDB-600 Specifikace Strana 52